These ITS entries refer to more than 10,800 taxa. This database hereafter referred to as the “”fungi database”" was compiled using EcoPCRFormat. To assess the specificity of the primers to fungi, we used the plant database PLX4032 price from EMBL (release embl_102, January 2010 from ftp://ftp.ebi.ac.uk/pub/databases/embl/release/)
to run amplifications using the same primers as for fungi. This database, hereafter referred to as the “”plant database”", contained 1,253,565 sequences, including approximately 65,000 ITS sequences (estimated from EMBL SRS website requesting for viridiplantae sequences annotated with ‘ITS’ or ‘Internal Transcribed Spacer’). These ITS entries refer to more than 6,100 taxa. This database was also compiled using EcoPCRFormat. As there are relatively buy Crizotinib few sequences submitted to public databases covering
the entire ITS region as well as the commonly used universal primer sites in the flanking SSU and LSU regions, we created three subset datasets covering either ITS1, ITS2 or the entire ITS region. From the initial fungi database, we compiled three subset databases (hereafter referred to as subset 1, 2, and 3) by in silico amplification (see below) of target sequences using the following primer pairs: NS7-ITS2 (dataset 1, focused on ITS1 region), ITS5-ITS4 (dataset 2, including both ITS1 and ITS2 regions) and ITS3-LR3 (dataset 3, focused on ITS2 region). To simulate relatively stringent PCR conditions, a single Pregnenolone mismatch between each primer and the template was allowed except in the 2 bases of the 3′ primer end. These three subsets were then compiled using EcoPCRFormat and included 1291, 5924 and 2459 partial nrDNA sequences, respectively. In silico amplification and primer specificity to fungi Using EcoPCR, we ran in silico amplifications from both the fungi and the plant databases using various commonly used primer combinations, to assess the number
of amplifications and the specificity of the primers to fungi. For each amplification, we allowed from 0 to 3 mismatches between each primer and the template (excluding mismatches in the 2 bases of the 3′ primer end) in order to simulate different stringency conditions of PCRs. Secondly, from the three subsets, we amplified sequences using different internal primer combinations in order to evaluate the various primers (Figure 1). From dataset 1 we used the primer combinations ITS1-F-ITS2, ITS5-ITS2 and ITS1-ITS2. From dataset 2 we used the combinations ITS1-ITS4 (amplifying both ITS1 and ITS2 introns), ITS3-ITS4 and ITS5-ITS2. From dataset 3 we used the combinations ITS3-ITS4 and ITS3-ITS4B. During these virtual PCRs we also allowed from 0 to 3 mismatches between each primer and the template, except in the 2 bases of the 3′ primer end.